GE JBP48 Range User Manual


 
12-Hour Shutdown
With this feature, should you forget and leave the
oven on, the control will automatically turn off the
oven after 12 hours during baking functions or
after 3 hours during a broil function.
If you wish to turn OFF this feature, follow
the steps below.
Touch the BAKE and BROIL HI/LO
pads at the same time for 3 seconds
until the display shows SF.
Touch the DELAY START pad until
no shdn (no shut-off) appears in the
display.
Touch the START pad to activate the
no shut-off and leave the control
set in this special features mode.
Fahrenheit or Celsius Temperature Selection
Your oven control is set to use the Fahrenheit
temperature selections but you may change this
to use the Celsius selections.
Touch the BAKE and BROIL HI/LO
pads at the same time for 3 seconds
until the display shows SF.
Touch the COOKING TIME and BROIL
HI/LO pads at the same time. The
display will show F (Fahrenheit).
Touch the COOKING TIME and BROIL
HI/LO pads again at the same time.
The display will show C (Celsius).
Touch the START pad.
Tones at the End of a Timed Cycle
At the end of a timed cycle, 3 short beeps will
sound followed by one beep every 6 seconds
until the CLEAR/OFF pad is touched. This
continual 6-second beep may be canceled.
To cancel the 6-second beep:
Touch the BAKE and BROIL HI/LO
pads at the same time for 3 seconds
until the display shows SF.
Touch the KITCHEN TIMER ON/OFF
pad. The display shows CON BEEP
(continuous beep). Touch the
KITCHEN TIMER ON/OFF pad again.
The display shows BEEP. (This cancels
the one beep every 6 seconds.)
Touch the START pad.
Cook and Hold
Your new control has a cook and hold feature that
keeps cooked foods warm for up to 3 hours after
the cooking function is finished.
To activate this feature, follow the
steps below.
Touch the BAKE and BROIL HI/LO
pads at the same time for 3 seconds
until the display shows SF.
Touch the COOKING TIME pad.
The display will show Hld OFF.
Touch the COOKING TIME pad again
to activate the feature. The display
will show Hld ON.
Touch the START pad to activate
the cook and hold feature and
leave the control set in this
special features mode.
Special features of your oven control. www.GEAppliances.com
Your new touch pad control has additional features that you may choose to use. The following are the features
and how you may activate them.
The special feature modes can only be activated while the display is showing the time of day. They remain
in the control’s memory until the steps are repeated.
When the display shows your choice, touch the START pad. The special features will remain in memory after
a power failure, except for the Sabbath feature, which will have to be reset.
Safety Instructions
Operating Instructions Care and Cleaning
Troubleshooting Tips Consumer Support
13