GE JBP48 Range User Manual


 
18
After a Clean Cycle
You may notice some white ash in the
oven. Wipe it up with a damp cloth after
the oven cools.
If white spots remain, remove them with a soap-
filled steel wool pad and rinse thoroughly with
a vinegar and water mixture.
These deposits are usually a salt residue
that cannot be removed by the clean
cycle.
If the oven is not clean after one clean
cycle, repeat the cycle.
You cannot set the oven for cooking or
another self-clean cycle until the oven
is cool enough for the door to unlock.
While the oven is self-cleaning, you can
touch the CLOCK pad to display the
time of day. To return to the clean
countdown, touch the SELF CLEAN
STD/LO pad.
If the shelves become hard to slide,
apply a small amount of cooking oil to
a paper towel and wipe the edges of
the oven shelves with the paper towel.
How to Delay the Start of Cleaning
Touch the SELF CLEAN STD/LO pad
once for a 3-hour clean time or
twice for a 4-hour clean time.
A 3-hour self-clean time is
recommended for use when
cleaning small, contained spills.
A self-clean time of 4 hours or
longer is recommended for
a dirtier oven.
If a time other than 4 hours or
3 hours is needed, use the number
pads and enter the desired
clean time.
You can change the clean time to any
time between 2
1
2 hours and 5 hours,
depending on how dirty your oven is.
Touch the DELAY START pad.
Using the number pads, enter the
time of day you want the clean cycle
to start.
Touch the START pad.
The door locks automatically. The display
will show the start time. It will not be
possible to open the oven door until
the temperature drops below the lock
temperature and the LOCKED light
goes off.
When the LOCKED light goes off, you
will be able to open the door.
Using the self-cleaning oven.
The oven door must be closed and all controls set correctly for the cycle to work properly.
Consumer Support Troubleshooting Tips Care and Cleaning Operating Instructions Safety Instructions