Filter
Top Products
Clock
To Set the Clock
&
The
clock
must be set
for
the
automatic oven timing functions
to
work properly. The time of day
cannot be changed during a Timed
D
CLOCK
‘“’’’’’pad”
(4!X7
Baking or CLEAN cycle.
2. Press the INCREASE or
DECREASE pad to set the
time of day.
-
3. Press the CLOCK pad to start.
Timer To Set the Timer
The timer is a minute timer; it does
(—j
1. Press the
not control oven operations. The
maximum setting on the timer is
TIMER
TIMER pad.
9
hours and 55 minutes.
2. Press the INCREASE or
DECREASE pad
to
set the
amount
of
time on the timer.
The timer will start automatically
within
a
few seconds of releasing
the INCREASE or DECREASE pad.
The timer, as you are setting it,
will display hours and minutes.
“HR” will be in the display.
During the countdown, when
the
timer reaches the last minute, the
display will change to seconds
only and a single beep will sound.
1-
To Reset the Timer
To Cancel the Timer
If both “SET” and “TIMER” are displayed, press the
Press and hold the TIMER pad until the word
INCREASE or DECREASE pad until desired time
“TIMER” disappears from the display.
is reached.
If only “TIMER” is displayed, press the TIMER pad
first, then follow the instructions above to set the timer.
End of Cycle Tones
Power Outage
The end of cycle tone is a series of 3 beeps followed
After
a
power outage, when power is restored, the
by 1 beep every
6
seconds. If you would like to
display will flash and time shown will no longer be
remove the signal that beeps every 6 seconds. press
correct-for example, after a 5-minute power
and hold the
CLEAIVOFF pad for
10
seconds.
interruption the clock will be 5 minutes slow.
To return the signal that beeps every 6 seconds, press
All other functions that were in operation when the
and hold the CLEAR/OFF pad for
10
seconds.
power went out will have to be programmed again.
Display Messages
programmed information can be
displayed at any time by pressing
the pad of the operation you want
to see. For example. you can
display the current time of day
while the timer is counting down
by pressing the CLOCK pad. Press
the TIMER pad to return
to
the
timer display.
To check the start time for Delayed
If “door” appears in the display,
Bake or Self-Clean, press and hold
LOCK flashes, and the oven
the COOK TIME or AUTO SELF
control signals you set the self-
CLEAN pad for 3 seconds. The
clean cycle and did not shut the
display will show the bake or clean
oven door.
start time for as long as you press
the pad. When you release the pad,
(cotttinued next p(lge)
the display will return to the time
of day.
19
--