Filter
Top Products
-
m
Questiom?
_
UseThis
fioblem
Solver
~
PROBLEM
POSSIBLE CAUSE AND REMEDY
~EN
WkL
N~
●
A
fise
in your home
m~
~
blown
or
tie
circuit breaker
tripped.
Replace fuse or reset
COME ON
circuit breaker.
●
Unplug
your microwave
oven, then plug it back in.
●
Make sure 3-prong plug on oven is fully inserted into wall receptacle.
CONTROL PANEL
*
Door not securely closed.
LIGHTED,
YET OVEN
~LL
N~
START
. START must be touched after entering cooking selection.
●
Another selection entered already in oven and CLEAR/OFF not touched to cancel it.
o
Make
sure you have entered cooking time after touching TIME COOK I & II.
. CLEAR/OFF was touched accidentally. Reset cooking program and touch
START.
c
Make sure you have entered a temperature after touching
TEMP COOK/HOLD.
●
Make sure you entered a code number after touching AUTO COOK, AUTO ROAST,
AU~
DEFROST or AUTO REHEAT.
FOODS ARE EITHER
@Cooking times may vary because of starting food temperature, food density or amount
OVERCOOKED OR
of foods in oven. Touch TIME COOK
I
& II and additional cooking time for completion.
UNDERCOOKED
●
Inco~ect
power
level
en~red.
Check
cookb~k
for
reco~ended
power level.
. Dish was not rotated, turned or stirred. Some dishes require specific instructions.
Check cookbook or recipe for instructions.
●
Too many dishes in oven at same
time.
Cooting
time must be increased when cooking
more than one food item. Check cookbook time recommendations.
. Dish not completely covered as directed during Auto Cook.
o
Previous microwaving left humidity or moisture in oven, thus lessening the cooking
time in Auto Cook function.
e
Cefin
vege~bles
ne~
a
s~nding time afier using Auto Cook. Check Automatic
Cooking Guide.
o
pro~
not
inse~
Prowrly
into meat or dish when using Temp CooWHold or Auto
Roast functions. Check cookbook for specific instructions.
“PRObE” APPEARS
●
Probe has been forgotten or not seated properly in oven wall when using Temp
ON DISPLAY Cook/Hold or Auto Roast.
“Error” APPEARS
●
During Auto Cook, Reheat or Popcorn program, the door was opened before steam
ON DISPLAY
could be detected.
. No steam was detected by sensor within four minutes and 10 seconds after start of
Popcorn program.
All these things are normal with your microwave oven:
●
Steam or vapor escaping from
. Dimming oven light and change
●
Some TV-Radio interference
around the door.
in blower sound
may occur while
might be noticed while using your
●
Light reflection around door or
operating at power levels other
microwave oven. It’s similar to the
outer case.
than high.
interference caused by other small
c
Dull thumping sound while oven
appliances and does not indicate a
is operating.
problem with your oven.
Ifyou need more help... call, toll free: GE Answer
Center@
/
8W.62&2W
/ consumer information service
34