Filter
Top Products
Proper care and cleaning are
important so your Range will give
you efficient and satisfactory
service. Follow these directions
carefully in caring for your range
to assure safe and proper
maintenance.
Finishes
The porcelain enamel finish is
sturdy but breakable if misused.
This finish is acid resistant. How-
ever, any acid foods spilled (such as
fruit juices, tomato, or vinegar)
should not be permitted to remain
on the finish.
CleaningUnder the Range
The area under the range of models
equipped with a bottom drawer can
be reached easily for cleaning by
removing the bottom drawer. l-o
remove, pull drawer out all the way,
tilt up the front and remove it. To
replace, insert glides at back of
drawer beyond stop on range
glides. Lift drawer if necessary to
insert easily. Let front of drawer
down, then push in to close.
Removable Oven Door
To REMOVE door, open to BROIL
position, or where you feel hinge
catch slightly. Grasp door at sides;
lift door up and away from hinges.
To REPLACE, grasp door at sides.
Line up door with hinges and push
door firmly into place.
oven Vent Duct
Your Range is vented through a
duct located under the right rear
surface unit. Clean the duct often.
To remove:
@Make sure unit is cool.
~ Lift up right rear surface unit.
@Remove drip pan and ring.
@Lift out oven vent duct.
I
To replace:
@Place the part over the oven vent
located below the cooktop with
opening of the duct under the
round opening in the drip pan. It
is important that the duct is in the
correct position so moisture and
vapors from the oven can be
released during oven use. NOTE:
Never cover the hole in the oven
vent duct with aluminum foil or
any other material. This prevents
the oven vent from working prop-
erly during any cooking cycle.
Cooktop Surface Lamp
WHEN CHANGI.NG LAMP, DO
NOT TOUCH THE METAL END
OF THE LAMP.
a.
Disconnectelectricpowerto
rangeat main fuseor circuit
breakerpanel.
b. Hold glasspanelassemblyand
removethe threescrewsfrom the
metalframe that holdstop of
assemblyin place.
c. Hold assemblyin both handsand
lowerit untilit is removed,
d. Removelampand replacewith
bulb of the samewattage.Liftglass
panelassemblyinto placeand
replacescrewsin top of assemblyto
hoid it in place.
e. Reconnect electricpowerto
range.
Oven Lamp
CAUTION: Before replacing your
oven bulb, disconnect the electrical
power for your range at the main
fuse or circuit breaker panel or pull
plug. Besure to let the-lamp cover
and bulb cool completely before
removing or replacing.
The oven lamp (bulb) is covered
with a glass, removable cover which
is held in place with a bail-shaped
wire. Remove oven door, if desired,
to reach cover easily.
1. TO REMOVE, hold hand under
cover so it doesn’tfall when released.
With fingers of same hand firmly
push down wire bail until it clears
cover. Lift off cover, DO NOT
REMOVE ANY SCREWS TO
REMO.VE THIS TYPE OF
COVER.
2, Replace lamp with 40-watt,
home appliance bulb.
3. TO REPLACE cover, place it
into groove of lamp receptacle. Lift
wire bail up to center of cover until
it snaps into place. When in place,
wire holds cover firmly, but be cer-
tain wire bail is not below depres-
sion in center of cover.
40 Connect electric power to range.
—
14