Filter
Top Products
OVEN CONTROL, CLOCK AND TIMER
;lock
To Set the Clock
The clock must be set for the
automatic oven timing functions to
work properly. The time of day
cannot be changed during a Timed
D
1. Press the CLOCK
CLOCK
pad.
n
2. Press the INCREASE
A
or DECREASE pad
~
to set the time of day.
Bake or CLEAN cycle.
3. Press the CLOCK pad to start.
Timer
To Set the Timer
The timer is a minute timer only.
The timer does not control oven
operations. The maximum
setting on the timer is
c1
1. Press the TIMER pad.
TIMER
9 hours and 55 minutes.
2. Press the INCREASE or
DECREASE pad to set the
amount of time on timer.
The timer will start automatically
within a few seconds of releasing
the pad.
The timer, as you are setting it,
will display seconds until 60
seconds is reached.
Then it will display minutes
and seconds until 60 minutes
is reached.
After 60 minutes, it will display
hours (“HR” now appears in
display) and minutes until the
maximum time of 9 hours and
55 minutes is reached.
To
Reset Timer
If “TIMER” is showing, press the
INCREASE or DECREASE pad
until the desired time is reached.
If “TIMER” is not showing, press
the TIMER ON/OFF pad first, then
follow instructions above to set
the timer.
To Cancel Timer
Power Outage?
Press the TIMER pad until the
After a power outage, when power
word “TIMER” quits flashing on
is restored, the display will flash
the display (about 4 seconds).
and time shown will no longer be
correct—for example, after a
5-minute power interruption the
clock will be 5 minutes slow.
The display flashes until the clock
is reset.
All
other functions that
were in operation when the power
went out will have to be
programmed again.
End of Cycle Tones
Display Messages
The end of cycle tone is 3 short beeps followed by
If “DOOr” appears on the display, the door is open.
1
beep that repeats every 6 seconds until you press
Close the door. If “LOCK” appears on the display, the
any operation. If you would like to eliminate the
oven door is in the locked position. BAKE, BROIL
repeating beeps, press and hold the CLEAR/OFF
and COOK TIME cannot be set if the door is in the
pad for 10 seconds.
locked position.
To return the end of cycle tone to the repeating beeps,
press and hold the CLEAR/OFF pad for 10 seconds.
11