GE JSP38GP Range User Manual


 
lass Ceramic Cooktop Cleaning
Cleaning of
glass
ceramic cooktops is different from
cleaning
a
standard porcelain finish.
To maintain and protect the surface
of
your new glass
ceramic cooktop follow these basic steps.
DAILY CLEANING:
Use only Cook Top Cleaning Creme on Glass
Ceramic.
For normal, light soil:
1.
Rub a small amount of Cook Top Creme onto
soiled area using a dry paper towel. Wipe until
d]
soil and creme are removed. Frequent cleaning
leaves a protective
couting
of silicone which is
essential in preventing scratches and abrasions.
2. Clean surface with Cook Top Cleaning Creme after
each use.
For heavy, burned on soil:
1.
Apply a few drops of Cook Top Cleaning Creme to
the (cool) soiled area.
2. Using a dry paper towel, rub creme into the burned
cm
area.
3. Carefully scrape remaining soil with razor scraper.
Hold scraper at a
30°
angle against the ceramic
surface.
4. If any soil remains, repeat the steps listed above.
For additional protection, after
all
soil has been
removed, polish the entire surface with the Cook
‘rOp
Cleaning Creme.
NOTE: Using a razor scraper will not damage the
surface if the 30° angle is maintained.
Store the razor
scraper out of reach of children.
PRECAUTIONS:
Most cleaners contain ammonia, chemicals and
abrasives which can damage the surface of your
cooktop. Use
only the Cook Top Cleaning Creme
for proper cleaning and protection of your glass
ceramic surface.
If
you slide aluminum or copper cookware across
the surface of your cooktop, they may leave metal
markings which appear as scratches. If this should
happen, use the razor scraper and Cleaning Creme to
remove these markings. Failure to remove these
residues immediately may leave permanent marks.
Special Care:
Sugary spillovers (such
as
jellies, fudge, candy
syrups) or melted plastics can cause pitting of the
surface of your cooktop unless the spill is removed
while still hot.
Special care should be taken when
removing hot substances.
Follow these instructions
carefully and remove soil while spill is still hot.
1.
Turn off
all
surface units affected by the spillover.
Remove hot utensils.
2. Wearing an oven mitt, hold the razor
6
scraper at a 30° angle to the cooktop
-7:
and scrape the hot spill to a cool area
-
outside the surface unit. Be sure to use
9
~..
:.,
//’
a
new, sharp razor scraper. do not use a
dull or nicked blade.
3. With the
spill
in a cool area, use a dry paper towel
to remove any excess. Any spillover remaining
should be left until the surface of the cooktop has
cooled. Do not continue to use the soiled surface
unit until all of the spillover has been removed.
Follow the steps under Heavy Soil to continue the
cleaning process.
General Information:
As the Cook Top Cleaning Creme cleans, it leaves a
protective silicone coating on the cooktop surface.
This coating helps to prevent build-up of mineral
deposits (water spots) and will make future cleaning
easier. Dishwasher detergents remove this protective
coating and therefore make the cooktop more
susceptible to staining.
If pots with a thin overlay of aluminum, copper,
or enamel are allowed to boil dry, the overlay may
bond with the glass ceramic and leave a black
discoloration. This should be removed immediately
before heating again or the discoloration may be
permanent.
Use of window cleaner may leave an iridescent
film on the cooktop. Cook Top Cleaning Creme
will remove this discoloration.
Water stains (calcium deposits) are removable
using Cook Top Cleaning Creme or full strength
white vinegar.
(continued next puge)
31