Filter
Top Products
I
I
i
------ .-..— —.
1
TO replace hood lamp, first dlscmmct powerag
mainfuseor clrcultWaker pfml or pull plug.
Remove2 screws from each side of lower panel and
3 screws from front edge. Lower panel until it rests
on range below. Be sure bulb to be replaced is cool
.
To replaceyour oven lamp,first Wmmnwt powerat
mainfuseorcircuitbreakeror pullplug.Removethe
top grill by taking off 2 screws which hold it In place,
Next, remove the single screw on top left that
secures lamp housing, (CM models so equipped,)
Openoven door for
easier removalof the lamp hous-
ing assembly.Then grasp tab and pu!! out and up to
clear door hinge and front tip of oven. To remove
bulb, push it inward gently and turn to left, then pull
outward from socket, Replace with GE Lamp
a ~~~~~~,
30 notattemptto operat~the ovenunlessth~grhim
nplace.
before removing, Removebulb or bulbs and replace
with 40 watt appliance bulbs. Raiselower oanel and
replace screwk;
waveoven.
Connect electrical power-to micro-
\\.
I
Clean off the grease and dust on hood surfaces
often. Usea warm detergent solution. About 1 table-
spoon of ammonia may be added to the water. Take
care not to touch the filters and enameled surfaces
with this. Ammoniawill tend to darkenmetal,
15