Filter
Top Products
Operating Instructions
Safety Instructions
Installation
Instructions
Troubleshooting TipsConsumer Support
42
Installation of the range.
IMPORTANT!
Remove all tape and packaging. Make sure the burners are properly seated and level.
Take the accessory pack out of the oven.
Check to be sure that no range parts have come loose during shipping.
LOCATION GUIDELINES
Do not locate the range where it may be subject to strong drafts. Any openings in the floor
or wall behind the range should be sealed. Make sure the openings around the base of the
range that supply fresh air for combustion and ventilation are not obstructed by carpeting
or woodwork.
Your range, like many other household items,
is heavy and can settle into soft floor coverings
such as cushioned vinyl or carpeting. Use care
when moving the range on this type of flooring.
It is recommended that the following simple and
inexpensive instructions be followed to protect
your floor.
The range should be installed on a sheet of plywood
(or similar material). When the floor covering ends at
the front of the range, the area that the range will rest
on should be built up with plywood to the same level
or higher than the floor covering.
This will allow the range to be moved for cleaning
or servicing. Also, make sure your floor covering
will withstand 180°F. (See the Installation Safety
Instructions section.)
Make sure the wall coverings around your range can
withstand the heat generated (up to 200°F) by the
range. (See the Installation Safety Instructions section.)
TOOLS YOU WILL NEED
■ Phillips and flat-blade screwdrivers
■ Pencil and ruler
■ Two pipe wrenches (one for backup)
■ Open-end or adjustable wrench
■ Nut driver or wrench: 1/4″
■ Drill
ADDITIONAL MATERIALS YOU MAY NEED:
■ Gas line shut-off valve
■ Pipe joint sealant or UL-approved pipe thread tape
with Teflon* that resists action of natural and LP
gases.
*Teflon: Registered trademark of DuPont
■ Flexible metal appliance connector (1/2″ I.D.). A
5-foot length is recommended for ease of installation
but other lengths are acceptable. Never use an old
connector when installing a new range.
■ Flare union adapter for connection to gas supply line
(3/4″ or 1/2″ NPT x 1/2″ I.D.)
■ Flare union adapter for connection to pressure
regulator on range (1/2″ NPT x 1/2″ I.D.)
■ Liquid leak detector or soapy water.
■ Lag bolt or 1/2 ″ O.D. Sleeve anchor (for concrete
floors only).
■ Squeeze Connector matching the size of the bracket
opening (on the range back behind the wiring cover)
and the house conduit. Obtain only if replacing the
power cord with conduit.