Filter
Top Products
ASSEMBLE BURNERS,
CHECK IGNITION
Assemble burner as shown.
CAUTION: Do not operate the burner without all
burner parts in place.
Place the burner heads on the burner bases matching the
letters. Place the caps on the heads. Make sure that the
heads and caps are placed on
the correct size burner. The
burner heads and burner bases
are labeled A, B and C to aid
reassembly. There is one small
(A), two medium (B) and one
large (C) head and cap.
Make sure the notch in the burner head is positioned
toward the electrode. Rotate the burner head around the
burner base until it is level and securely seated.
Place the grates over the burners.
Check for proper ignition:
• Push in one control knob and turn to LITE position.
• The igniter will spark and the burner will light; the igniter
will cease sparking when the burner is lit.
• First test may require some time, while air is flushed
out of the gas line.
• Turn knob to OFF.
• Repeat the procedure for each burner.
INSTALL DOWNDRAFT FILTER,
VENT GASKET AND VENT GRILLE
Do not operate the vent without the filter in place.
• Place the filter diagonally through the vent opening.
• Make sure it rests, at an angle, on the supports in the
vent opening.
• Fit the vent grille gasket around the edge of the
downdraft vent opening. Make sure the front of the
gasket is installed toward the front of the cooktop.
• Carefully place the vent grille onto the gasket on the
downdraft opening.
CHECK OPERATION OF DOWNDRAFT
• Turn the vent fan speed control to HI, MED and
LO to make sure all speeds operate correctly.
18
Vent Filter
Vent
Chamber
Installation Instructions
FINAL ASSEMBLY
19
Grate
Burner head
Burner cap
Electrode
Burner base
Medium
Head
and Cap
Medium
Head
and Cap
Front of Cooktop
Curved side
toward the
center
30
Grille
Vent Grille
Gasket
Small
Head
and Cap
Large
Head
and Cap