Filter
Top Products
Using the hood controls.
Throughout this manual, features and appearance may vary from your model.
A - MOTORSTOP
B - SPEED DECREASE
D - LED:SPEED 1
F - LED: SPEED 2 AND METAL FILTER SATURATION
(WHEN FLASHING)
C - LED: SPEED 3 AND COAL FILTER SATURATION
(WHEN FLASHING)
E - MOTOR START AND SPEED INCREASE
G - TIMED INTENSIVE SPEED
H - LED TIMED INTENSIVE SPEED
I - “ON-OFF’ LIGHT
- MOTOR OPERATING PERFORMANCE CHECK-
UP. WHEN ANY OF THE BUTTONS ARE
PRESSED, ALL FOUR LEDS TURN ON TO
INDICATE THAT THE FOUR FAN SPEEDS
OPERATE PROPERLY. IF ONE OF THE LIGHTS
DOES NOT COME ON, IT MEANS THAT THE
SPEED CORRESPONDING TO THAT LIGHT
DOES NOT WORK.
Consumer Support
Troubleshooting Tips Operating Instructions
Safety Instructions
Care and Cleaning
4
Control Device Reset
Grease Filters:
After cleaning the grease filters, press buttons (A)-(E) for
2 seconds until you hear the beep and the LED stops
flashing.
Coal Filter:
After replacing the cartridge, press both buttons (A)-(B)
for 2 seconds until you hear the beep. The LED will stop
flashing.
The coal filter saturation is also indicated when the hood
is used in vented version.
The hood is provided with a storage device which counts
the number of hours of operation and which regulates
the lighting up of the coal filter saturation LEDS.
For the correct operation of this device, it is important
that the hood be switched off by pressing button (A)
before unplugging it for any maintenance work.
ABDFCEGH
I
Hood Operation
Turn the fan on for approximately 5 minutes before you
start cooking in order to create some upwards drafts
through the hood.
This causes the heat, smoke, steam, grease and odours
produced during cooking to be pushed outwards, thereby
preventing them from drifting into other rooms.
Use the low speed settings for normal use and the high
speed settings for strong odours or thick smoke.
The presence of drafts in the kitchen or in the hood
reduces the efficiency of the hood. These drafts
should be avoided wherever possible.
Filters
To remove the metal grease filter/s:
■ Unplug the hood from the mains
socket.
FOR MODELS PVIG940, PVWG936
■ Press the clips towards the centre and
remove the filters. Fig. 1.
FOR MODELS PVWS930, PVWS936,
PVWT936
■ Press the handles and remove the
filters. Fig. 2.
To replace the metal grease filter/s:
■ Follow the same procedure, but
backwards.
The metal grease filters are manufactured using anodised aluminium and have an unlimited duration.
Fig. 1
Fig. 2