Filter
Top Products
Installation Instructions
INSTALLING THE ICEMAKER
HANG THE ICEMAKER ON
FREEZER WALL
•
Slip the stainless steel clip over the wall of the
water cup.
•
Screw one 5/8″ icemaker mounting screw in the top
front hole. Leave the head out approximately 3/8″ for
the slot in the icemaker hanger to slip over the screw.
•
Hold the icemaker in position inside the freezer. Insert
the wire harness plug into the outlet using a rocking
motion, until the locking fingers on the sides of the
plug snap into place. The plug fits only one way.
•
Slip the icemaker hanger over the mounting screw,
while easing the icemaker water cup toward the end of
the water fill tube. The water fill tube fits under the
stainless steel clip on the water cup. The water fill tube
must not be kinked. It should extend approximately
1/2″ into the water cup and must not become easily
dislodged.
•
Screw in the two remaining icemaker mounting screws.
Tighten all three screws.
4
Stainless
steel clip
Start this
screw first
Hangers
Water fill
tube
Wire
harness
outlet
Water
cup
PLACE ICE STORAGE BIN ON
FREEZER SHELF.
Move the ice storage bin into place directly under
the icemaker.
NOTE: Check again to make sure the icemaker
power cord is fully inserted into its outlet.
Check again to make sure the icemaker feeler arm
is in the STOP (up) position.
6
APPLY WARRANTY LABEL TO
BACK OF REFRIGERATOR.
A label is provided in the kit. On it record the date of
the installation for warranty purposes.
7
LIFT THE ICEMAKER FEELER ARM
TO THE STOP (UP) POSITION.
The icemaker should feel secure when you lift the
arm. Leave the feeler arm in the STOP (up) position
until the refrigerator is connected to the water
supply to prevent it from operating before the water
supply connection is complete.
5
Feeler arm in STOP
(up) position
Arm down—
icemaker will
operate
Arm up—
stops operation
The icemaker installation is now complete.
Refer to the following instructions for connecting
the icemaker to the home water supply.
9