Filter
Top Products
GE Consumer & Industrial
Appliances
Installation Instructions
WR49X10180 Kit–Domestic
WR49X10175 Kit–International
IMPORTANT – Observe all governing codes and
ordinances.
Note to Installer – Be sure to leave these instructions
with the Consumer.
Note to Consumer – Keep these instructions with your
Owner’s Manual for future reference.
Stop Sign
BEFORE YOU BEGIN
Read these instructions completely and
carefully.
TOOLS AND
MATERIALS
NEEDED:
• Phillips screwdriver
• Flathead screwdriver
• 5/16" hex head
nut-driver
• Razor knife
• Tape
• Drill
WARNING:
To prevent electric shock, disconnect electrical power
supply to refrigerator before beginning kit installation.
Triangle Warning
KIT CONTENTS:
• AC foil heater assembly
• Wire ties (3)
• Crimp style wire connectors (3)
• Aluminum tape – 1-1/4"
• White vinyl tape – 1-1/2"
• Jumper harness
• Grommet
• RTV102 (2)
• EPS beverage center L-insert
• Fresh food evaporator EPS
block
• Air return EPS block
• Evaporator tube foam
insulation
• Beverage center duct
• 1/2” Pilot tip drill bit
The ice ball problem is being caused by very low
temperatures in the lower left part of the fresh food
compartment. The low temperatures are being driven
by two gaps that need to be sealed. One around the
beverage center duct and one along the left side curved
geometry of the Quick Chill air handler cover.
These two locations need to be sealed with RTV.
REMOVE POWER TO THE UNIT BEFORE PERFORMING
KIT INSTALL.
REMOVE ALL ICE AND MOISTURE FROM ALL REPAIR
AREAS.
SOME 25 CU. FT. BIS MODELS DO NOT HAVE
BEVERAGE CENTERS.
CHECK FOR WIRES ALREADY ROUTED WITH DC
(RIGHT FRONT) HARNESS IN FRESH FOOD
COMPARTMENT. IF THERE ARE WIRES THERE, A DC
KIT HAS BEEN INSTALLED. IF DC KIT WAS INSTALLED
ALREADY, CONNECTION TO MAIN BOARD MUST BE
REMOVED AND HARNESS CUT SHORT.
Triangle Warning
Triangle Warning
Triangle Warning
Triangle Warning