Filter
Top Products
Step 19
Disconnect main power cord 6-pin connector. Place
heater jumper harness in line (Figure 15). Coil excess
wiring and wire tie. Tuck excess wiring back in machine
compartment (Figure 16). Ensure that all harness
connectors are secure; some may be loose from factory.
Figure 15
Step 20
Apply power back to unit and ensure both unit and
heater are operational. Listen for compressor and feel
heater with back of hand. Heater surface will be slightly
warmer than surrounding left wall surface. Go back and
ensure that heater assembly is directly touching the left
sidewall. Heater may have shifted during wire routing.
Step 21
Replace cover on machine compartment. Ensure that no
wires are being pinched between the cover and the case
back. Replace unit to original position in home.
Step 22
Remove plate covering water tube to the filter (Figure 17).
RTV sealing the tubes to the foam to prevent any possible
air leaks.
Figure 16
5
Step 18
Use the bell/crimp style wire connectors to connect the
heater wiring to the jumper harness (Figure 14).
Figure 14
Step 23
Check gasket around fresh food door and freezer door for
tears or gasket rollover. Repair/replace as necessary.
Figure 17
Figure 17