Filter
Top Products
Step 12
RTV around the underside of the grommet lip (Figure
10). Insert grommet into hole. Ensure it is pressed
completely in, until the base of the grommet lip touches
the fresh food floor surface. Clear excess RTV for clean
appearance.
Figure 10
Step 13
Use a wire tie to attach the heater wire to the AC harness
(right rear harness) for strain relief inside the fresh food
compartment. Clip off excess wire tie. Keep the spacing
between the heater wire and the DC (right front) harness
as large as possible (Figure 11).
Figure 11
Step 14
Route the heater assembly wire down through the
installed grommet. Fill inside of grommet around harness
with RTV to prevent air leaks (Figure 12).
Figure 12
Step 15
Reinstall all fresh food compartment components. Pull
out unit. Remove machine compartment cover.
Step 16
Remove the water valve assembly to provide clearance
to connect wiring.
Step 17
Use a wire tie to attach the heater wire to the AC harness
as a strain relief in the machine compartment. Try to
keep spacing between the heater wire and the rear
entering DC harness as large as possible (Figure 13).
Figure 13
4