Filter
Top Products
19
Electrical Supply:
The built-in gas downdraft cooktop features
pilotless electric ignition for energy savings and
reliability. It operates on a 120 volt, 60 Hz power
supply. A separate circuit, protected by a 15 amp
time delay fuse or circuit breaker, is required.
• A properly grounded 3-prong receptacle
should be located within reach of cooktop’s four
foot power cord.
IMPORTANT: (Please read carefully.)
FOR PERSONAL SAFETY, THIS
APPLIANCE MUST BE PROPERLY
GROUNDED.
The power cord of this appliance is equipped
with a three-prong (grounding) plug which
mates with a standard three-prong grounding
wall receptacle to minimize the possibility of
electric shock hazard from this appliance. The
customer should have the wall receptacle and
circuit checked by a qualified electrician to
make sure the receptacle is properly grounded
and has correct polarity.
Where a standard two-prong wall receptacle is
encountered, it is the personal responsibility and
obligation of the customer to have it replaced
with a properly grounded three-prong wall
receptacle.
Do Not, Under Any Circumstances, Cut Or
Remove The Third (ground) Prong From
The Power Cord.
Do not use an extension cord.
POWER SUPPLY LOCATIONS
Gas Supply:
These cooktops are designed to operate on
natural gas at 4″ of water column pressure or
on LP gas at 10″ of water column pressure.
• These cooktops are shipped from the factory
set for natural gas. If you decide to use this
cooktop with LP gas, conversion adjustments
must be made by a service technician or other
qualified person.
•The pressure regulator must be connected in
series with the manifold of the cooktop and must
remain in series with the supply line regardless
of type of gas being used.
For proper operation, the maximum inlet
pressure to the regulator must be no more than
10″ water column pressure for natural gas and
14″ water column pressure for LP gas.
• When checking the regulator, the inlet
pressure must be at least 1″ greater than the
regulator output setting.
If the regulator is set for 4″ of water column
pressure, the inlet pressure must be at least 5″.
If the regulator is set for 10″ of water column
pressure, the inlet pressure must be at least 11″.
For ease of installation, and if local codes permit,
the gas supply line into the cooktop should be
1/2″ or 3/4″ ID flexible metal appliance
connector, three to five feet long.
NOTE: Purchase a new flexible line. DO NOT
USE AN OLD PREVIOUSLY USED LINE.
•Make gas connection through rear wall, or on
cabinet floor at rear, as illustrated.
(continued next page)
19″
4″
14″
Gas location
Electric location