Filter
Top Products
23
STEP 10
Install Filters, Check Operation of Downdraft
To raise the vent, turn the VENT knob to
RAISE/LOWER.
• Hold the knob until the vent begins to raise.
The vent will automatically stop when it is fully
extended.
• Tip filter into the opening and pull straight
down so that the filter rests on slides.
• Slide the filter to the right side.
• Tip the other filter into the opening and pull
straight down.
• To turn the fan on, turn the FAN knob to
HIGH. Continue turning the FAN knob to select
a fan speed between HIGH and LOW.
NOTE: It is not necessary to turn the fan
OFF before lowering the vent. The fan will
automatically turn off when the vent is lowered.
When the fan is not turned off before lowering
the vent, it will automatically come on at the
previously selected speed when the vent is
fully raised.
To lower the vent, turn the VENT knob to
RAISE/LOWER. Hold the knob until the vent
begins to lower.
STEP 9
Assemble Burners, Check Ignition
Assemble burner as shown.
Check for proper ignition:
• Push in one control knob and turn 90° to
HIGH position.
• The igniter will spark and the burner will
light; the igniter will cease sparking when the
burner is lit.
• First test may require some time, while air is
flushed out of the gas line.
• Turn knob to OFF.
• Repeat the procedure for each burner.
Top grate
Burner cap