Filter
Top Products
11
Clock and Timer
Wall Oven
Double oven clock and timer
Single oven clock and timer
Using the
clock and
timer
When you first turn on the power to your oven,
or after a power failure, the display will show
all 8’s, then dashes and the set clock symbol.
To set or change the time of day, press the
CLOCK button. The control will beep. The set
clock symbol will appear in the display.
Press the increase “▲” or decrease “▼” button.
If the increase “▲” or decrease “▼” button is
pressed and released, it will change the time in
one minute increments. If the increase “▲” or
decrease “▼” button is pressed and held, the
time will change in 10 minute increments.
Once the clock is set, press the CLOCK button
again. The control will beep and the set clock
symbol will disappear.
To check the time of day when the timer is in
use, press the CLOCK button. The time of day
will be displayed briefly and then will return
to the timer function.
The timer button does not control oven
functions. The timer may be used as a
convenient kitchen timer.
To set, press the TIMER button. The control
will beep. The display will show “:00” and the
words SET TIMER.
Press the increase “▲” or decrease “▼” button
to set the amount of time desired.
If the increase “▲” or decrease “▼” button is
pressed and released, it will change the time in
one minute increments. If the increase “▲” or
decrease “▼” button is pressed and held, the
time will change in 10 minute increments.
The timer will start automatically. The colon
blinks when the timer starts counting down.
The word TIMER will remain in the display
during the countdown. The timer will count
down in minutes until the last minute, then it
will count down in seconds.
When timing is complete, the word TIMER
will blink and the control will beep three
times. The display will return to the time of
day or any active programmed function and
the control will beep twice every 10 seconds
until any button is touched.
To cancel the timer, press the TIMER button
once. If no time is set, the timer cancels itself
after approximately 5 seconds. The time of day
is then displayed.