Filter
Top Products
Installation
Component Cooking Surfaces
7
Installation
Tools and materials
● 1/4”nutdriver
● Flanged joiner nurs (supplied)
Step
required:
●5/16° nutdriver QTwo hex-head bolts (choice
● Measuring tape ● 7/16“ and 5/16” socket and
of two lengths supplied)
● Pencil
ratchet wrench
● Hold-down brackets
Halogm/Radiant I$&’~eSivegasketStrip
● #2 Phillips screwdriver bit
(supplied)
cookt+, updra~ -
socket
● Cable-ties
(supplied)
● Philiips screwdriver
● Clean towel
grz”lland
doumdrafip”ll
If installing a downdraft grill cooktop and blower that
requires reorientation and/or relocation, refer to
“ReOtient Blowern and “Relocate Blower”.
Gas
cookt~
Tools and materials
required:
● Self-adhesive gasket strip
(supplied)
● Measuring tape
● Pencil
● Scissors
● Flanged joiner nuts (supplied)
● Two hex-head bolts (choice
of two lengths, supplied)
● 1/4” nutdriver
● Gas pressureregulator
(supplied)
● Largeflat-blade screwdriver
● Saw
● Carpenter’s square
● Pipe wrench
● 3/4” NPT x 3/4” I.D. or
1/2” NPT x 1/2” I.D. flare
union adaptor
● 1/2” NPT x 3/4” I.D. or
1/2” I.D. flare union adaptor
● Gas-resistant pipe joint
sealant
● 5 foot AGA-certified flexible
metal appliance connector,
3/4” or 1/2’ I.D. to match gas
supply line.
- If required by local codes,
use solid pipe with fittings
as required.
A@lj
gasketstrip
Llagfam 501
. Apply foam tape (provided) on top surface of counter-
top precisely along edge of cutout on all four sides.
Remove knobs “
and tm”m
.
.
Turn all control knobs to OFF position.
Carefully remove cooktop and downdraft vent
component control knobs by lifting (with fingers only)
straight up.
Note: To prevent scratching
Remove all grates, burner caps and vent covers from
knobs, remove them from unit
before it is turned face down.
components,
50