Filter
Top Products
14
After approximately 3 seconds, the display goes into the password entry mode:
<END ◄ ► A
BCDEF>
█
To enter the password, use the Tuner/Select DIAL or the UP/DOWN buttons on the remote to
select each letter/number/symbol of the password in turn, pressing OK after each letter.
NOTE: WEP and WPA passwords are upper and lower case sensitive and MUST be
entered exactly
HINT: Use the
’Back’ button to erase incorrect characters as you may have entered.
IF the display shows: “Invalid key” or “Network Error”, an incorrect password has
probably been entered or the correct password has been entered incorrectly with the
wrong case or in the wrong order, etc.
After entering the final letter/number/symbol, scroll to find and select END and press OK.
Once the password is entered correctly, your TUNER should now be able to connect to the
selected network.
Your tuner should now be able to connect to the selected network without having to re-enter a
password. Your password will be saved in your Grace tuner even if a power outage occurs.
You will have to alter your password however, should you attempt to connect to an alternative
wireless network
NOTE: IF you would like to give your tuner a static IP address refer to the ‘Network config’
section under the ‘Setting’ section.