Filter
Top Products
Page 7
P200/RAPS200 Brewers
To Drain The Water Tank
CAUTION: HOT LIQUIDS / BURN HAZARD
WATER IN TANK IS VERY HOT. USE CAUTION WHEN DRAINING TANK.
ACCIDENTAL SPILLS MAY RESULT IN SEVERE BURNS.
1) Shut off power to brewer.
2) Remove the top panel.
3) Remove the warmer shelf.
4) Pinch or clamp the tube from fill valve to tank (near tank entry on bottom).
5) Disconnect rubber tube from outlet barb on fill valve.
6) Pull tube through the brewer body so that it exits at the bottom.
7) Place tube over drain and release clamp.
To Remove The Heater
1) Disconnect power and remove top cover of brewer.
2) Disconnect wire leads to heater.
3) Remove tank cover by loosening retaining nuts. Remove heater from cover.
4) Replace heater with sealing washers in same configuration. When tightening nuts, hold
element so it does not twist.
5) Replace tank cover.
6) Replace heater wires. Be sure all electrical connections are secure.
7) Replace top cover of brewer and connect power cord to outlet.
Service
The rest of this manual contains information to help the service person who is working on this
equipment. This section has information on performing common service tasks.