Grizzly G0492 Bread Maker User Manual


  Open as PDF
of 76
 
"')"
<%).'&'M(+8dbWdAVi]Z$B^aa
I]ZYZVYXZciZg^hjhZY^ci]ZiV^ahidX`VcYaVi]Z
he^cYaZ id hjeedgi ldg`e^ZXZh# L]Zc jhZY ^c
i]ZiV^ahidX`!bV`ZhjgZid`ZZei]ZBI(YZVY
XZciZgi^eVcYldg`e^ZXZajWg^XViZYidegZkZcii^e
\Vaa^c\#
I]^haVi]Z$b^aa^hVahdhjeea^ZYl^i]VcBI*YZVY
XZciZgi]Vi[^ih^cidi]ZaVi]Zhe^cYaZiVeZg#
To install a dead or live center:
1. ;ZZY i]Z fj^aa dji VWdji & VcY ^chZgi i]Z
BI(YZVY XZciZgFigure 24# I]ZbVi^c\
iVeZghegdk^YZi]ZadX`^c\VXi^dc#
Figure 25.;VXZeaViZVcYYZVYXZciZghZije#
NOTICE
Failure to keep dead center point well
lubricated will gall the dead center and
workpiece.
Using the Centers
To install the MT#5 dead center in the spin-
dle:
1. 9>H8DCC:8I EDL:G ID I=: A6I=:$
B>AA
2. GZbdkZi]ZX]jX`[gdbi]Zhe^cYaZ#
3. >chiVaai]ZBI*YZVYXZciZg^ci]Zhe^cYaZ#
4. 6iiVX] i]Z [VXZeaViZ id i]Z he^cYaZ! hZZ
Figure25#
Note: When using the dead center in the
spindle, use a lathe dog so that your part will
rotate with the spindle and not spin on the
dead center tip.
Figure 24.>chZgi^c\YZVYXZciZg#
2. BdkZ i]Z iV^ahidX` ^cid edh^i^dc VcY adX` ^c
eaVXZ#
3. ;ZZYi]Zfj^aa^cidi]Zldg`e^ZXZ#
Note: Make sure there is a center drilled hole
in the end of the workpiece for the dead cen-
ter.
4. AdX`i]Zfj^aa^cideaVXZdcXZi]Za^kZXZciZg
VcY i]Z eVgi gdiViZ id\Zi]Zg# I]Z fj^aa bVn
cZZYidWZVY_jhiZYYjg^c\deZgVi^dc#
5. IdgZbdkZi]ZYZVYXZciZg!gZigVXii]Zfj^aa
jci^ai]ZYZVYXZciZgedeh[gZZ#
 previous next