Filter
Top Products
H8172 Cement Mixer -9-
Assembly
To assemble the cement mixer:
1. Insert the wheels on the axles and secure
them in place with the hairpin cotter pins, as
shown in
Figure 3.
Figure 3. Wheels installed on axles.
2. Attach the support leg to the frame with two
M8-1.25 x 65 hex bolts on one side and two
8mm flat washers, lock washers, and hex
nuts on the other side (
Figure 4).
Figure 4. Support leg installation.
3. Connect the upper and lower plunger rods
together with an M6-1 x 25 hex bolt and M6-
1 lock nut, then insert the cotter pin where
shown in
Figure 5. Bend each leg of the cot-
ter pin outward so it can't fall out.
Figure 5. Plunger rod installation.
4. Attach the axle bracket to the frame with two
M8-1.25 x 65 hex bolts on one side and two
8mm flat washers, lock washers, and hex
nuts on the other side (
Figure 6).
Figure 6. Attaching axle bracket to frame.