Filter
Top Products
15
1. Grasp sides of dishwasher door and put dishwasher on its back.
2. Remove two screws “A” attaching access panel “B”
and lower panel “C” to dishwasher using a ¼” hex
socket,nut driver or Phillips screwdriver. Remove
panels and set panels aside on a protective surface.
Check that grounding clip “D” is attached to the
lower panel.
3. Apply pipe joint compound “E” to 90° elbow fitting
“F” and connect fitting to water inlet valve “G”.
Tighten elbow until snug, and be sure that it faces to
the rear.
4. Remove terminal box cover “H”. Pull appliance wires
“I” through hole in terminal box. Do not untie the
knot in the wires.
If you are direct wiring: install a cUL-
listed/CSAcertified clamp connector “J” to the
terminal box. If using conduit use a cUL-listed/CSA
certified conduit connector.
If you are installing a power supply cord kit, do so
now and follow kit instructions.
HELPFUL TIP:
Put cardboard under dishwasher until it is installed. The cardboard will help protect
floor covering during installation.