Filter
Top Products
10. Use pliers to open clamp “N” and slide clamp onto
connector “P” between ribs “O” on connector.
9. Push the drain hose into the connector “P” up to
the rib “O” on the drain hose.
8. Place the smaller drain hose clamp “N” onto the
small end of the drain hose “O”. Remove the plug
from the connector “P”.
23
5. To prevent vibration during operation, route the
water supply line so that it does not touch the
dishwasher base, frame or motor. Make sure the
water line stays within the shaded area shown on
page 7 when the dishwasher is installed in the
cabinet. With copper tubing “J” pushed into
compression fitting as far as it will go, use an
adjustable wrench and tighten compression fitting
nut “I” to elbow “L” on water inlet valve.
6. Place Paper towel under elbow. Turn on water supply and check for leaks.
Drain Connection
7. To help minimize vibration noise, route drain hose
to avoid contact with motor, door springs, water
line, cabinet, flooring or the edge of the hole where
it passes through the cabinet.
Do not remove drain loop “N” from side of
dishwasher.