Filter
Top Products
18
13. Check the door spring tension. With another person
holding the dishwasher to prevent it from tipping, open
and close the door a few times. If the door opens by
itself, adjust the door spring tension.
To adjust the door spring tension, unhook the spring
“T” from the rear leg of dishwasher. With a
5
/16” nut
driver or hex socket, remove the screw ”U” from the
tensioner “V”. The screw can be put into one of three
holes “1”, “2”, “3”, in front leg of dishwasher. The
dishwasher is shipped with the screw in the back hole.
If the door opened by itself, move the tensioner to hole
“2” or “3” and replace screw. Re-attach door spring to
rear leg. Tensioners on both sides of dishwasher should
be secured at same holes.
14. Grasp the dishwasher door at the edges of the door
panel “W”. Tilt dishwasher backwards on wheels “X”.
Move dishwasher close to cabinet opening. DO NOT
PUSH ON FRONT OF PANEL OR ON CONSOLE - THEY
MAY DENT.
15. If dishwasher has a power supply cord, insert power
supply cord into hole cut into cabinet.
16. Check that water line is on the left side of opening and
drain hose is near the center of the hole in the cabinet.
If using direct wire, check that it is on the right side of
opening.
17. Carefully move dishwasher completely into cabinet
opening. Do not kink or pinch copper tubing, drain
hose, power supply cord or direct wire between
dishwasher and cabinet.
Center dishwasher in opening.