Filter
Top Products
8
1. Unplug blender from electrical outlet.
2. Wipe blender base, control panel,
and cord with a damp cloth or
sponge. To remove stubborn spots,
use a mild, non-abrasive cleanser.
3. To clean jar, unscrew cutting assem-
bly from jar.
4. Carefully remove gasket from cutting
assembly.
5. Remove dispenser from cutting
assembly.
• Rotate dispenser assembly 90
degrees
counter-
clockwise to
unlock from
cutting
assembly.
• Pull to remove dispenser assembly
from cutting
assembly.
• To unsnap actuator from hinge on
dispenser,
push dis-
penser with
thumb while
pulling dis-
penser lever
with fingers.
This releases
dispenser
from hinge.
How to Clean
• Lift and rotate actuator around
hinge.
Unscrew
dispenser
cap.
• Lift dispenser cap and actuator
straight up
to remove
the interior
plug
attached to
the cap
from the
dispenser
body.
6. To separate thermal jar, hold top of
blender jar and turn thermal jar
counterclockwise.
7. Carefully wash cutting assembly,
dispenser assembly parts, gasket,
jar, and lid in hot, soapy water. Rinse
and dry thoroughly. Do not soak.
Do not wash cutting assembly,
dispenser assembly parts, gasket,
jar, or lid in a dishwasher.
8. Reassemble cutting unit assembly
onto jar, and replace jar onto blender
base. Ensure dispenser or spout cap
is fully pushed on spout and rotated
clockwise to lock into position
(reverse steps in number 5 above).
9. Store blender with lid ajar to
prevent container odor.
Electrical Shock Hazard
• Disconnect power before cleaning.
• Do not immerse cord, plug or base
in any liquid.
Failure to follow these instructions can
result in death or electrical shock.
WARNING
840131900 ENv01.qxd 2/22/05 10:40 AM Page 8