Filter
Top Products
8
Installation of Ducting
Installation through an outside wall
Remove air deflector (used for ventless operation only). Cut appropriate-sized hole through the wall directly behind
the range hood outlet (see Figure 6 ,page 7), making sure no wall studs are cut. Push range into position. From
outside of the house, measure distance from the siding to the range outlet. Cut duct pipe that length, plus 1" (25mm)
for overlap into outlet. Attach vent hood to pipe. Caulk the back of vent hood and around pipe where it goes through
wall and into range hood outlet so caulking seals against outside siding.
Complete installation by following directions under Ventless Installation.
Installation through an attic
to an outside wall
If the vent elbows are
embedded in the wall, the
range may be positioned as
shown in Figure 6. Continue
the duct through the ceiling
into the attic. Terminate duct
either on an outside wall just
below the sofit using a vent
hood or through the roof with
a roof cap. Seal with caulking
around and under cap or hood.
Complete your installation by
following directions under
Ventless Installation.
Model 9100
Model 7100
19"
483
mm
66
1/4"
1682
mm
56
"
1416
mm
36
1/8"
917
mm
9 ¼"
235
mm
Range
Ho od
Outlet:
3
1/4"
x
10"
83
mm
x
254mm
Power
In
(
8 ft (2.4m) cord supplied
direct
con ect)
Exhaust
Hood
In
(female
recepticle)
1
1/4
"
32
mm
29
3/4
"
756
mm
31.0"
787
mm
14"
356
mm
38 1/4"
72 m m9
47 1/2"
1207 m m
33/4"/92mm
R ange Hood
Outlet : 3 1/4"x 10"
83 m m x 254mm
34 "
864 mm
36 1/8"
917 mm
29 3/4"
756 mm
62 3/8"
1585 mm
66 1/4"
1682 mm
14 7/8 "
378mm
Exhaust
HoodIn
56"
1422 mm
14.0"
356 m m
29 3/4 "
756 m m
31.0"
787 mm
Power In
(
8 ft (2.4m) cord
supplied
direct
connection)
2"
51 mm
Gas Inlet-1/2 NPT
29 3/4"
756 mm