Filter
Top Products
This section provides procedures for the checkout and replace-
ment of the various parts used within the fryer. Before replac-
ing any parts, refer to the Troubleshooting section. It will aid
you in determining the cause of the malfunction.
This section is arranged in groupings of the components that
work together within the fryer. The general groups are listed
below.
Removing the Control Panel
Probe
Electrical Components
Control Board
Pressure System
1. You may want to use a multimeter to check the electric
components.
2. When the manual refers to the circuit being closed, the
multimeter should read zero unless otherwise noted.
3. When the manual refers to the circuit being open, the
multimeter will read infinity.
Moving the cookpot with hot shortening in the cookpot
or filter pan is not recommended. Hot shortening can
splash out. Severe burns could result.
4. The weights can be removed from the frame to easily
access the rear of cooker.
This high temperature control is a manual reset control which
senses the temperature of the shortening. If the shortening
temperature exceeds 420°F (215”C), this control switch will
open and shut off the heat to the eookpot. When the
temperature of the shortening drops to a safe operation limit,
the control must be manually reset. The reset button is located
above the filter knob in the front of the cooker. This will allow
heat to be supplied to the cookpot.