Filter
Top Products
With the carrier and racks installed on the lid, the lid should
stay down, in contact with the pot rim, when the lid is lowered.
The user will then be able to lock the lid in place. If the lid
has a tendency to rise up before getting the lid locked down,
the magnet plate probably needs adjusting. Follow these steps:
1. Remove the six nuts securing the back shroud and remove
back shroud.
2. Loosen the bottom nut under the plate and unscrew both
nuts a couple turns, then lower the lid again to see if the
lid stays down. If not, repeat procedure.
3. Tighten lower nut up against the other nut and install back
shroud - adjustment is now complete.
This is an electromechanical device that causes pressure to be
held in the cookpot. The solenoid valve closes at the beginning
of the cook cycle and opens automatically at the end of the
cook cycle. If this valve should become dirty, or the Teflon seat
nicked, pressure will not build up. The electric fryer uses a
208/240 volt, 60 hertz coil (50 hertz internationally). The gas
uses a 120 volt, 60 hertz coil (208/240 volt, 50 hertz
internationally).
Before starting repair procedures! move the
Power/Pump Switch to the “OFF” position. Discon-
nect main circuit breaker at the circuit breaker box
and/or unplug service cord from the wall receptacle or
electrical shock could result.
Remove the solenoid wires from the wire nuts which are found
behind the control panel. Check across wires.
RESULTS
208/240 Volt, 60 Hertz 150 Ohms
208/240 Volt, 50 Hertz 230 Ohms
120 Volt, 60 Hertz 50 Ohms