Filter
Top Products
ee
The ignitors are electrically energized and the tip of the ignitor
glows red creating combustion in the burner chamber. It then
senses the combustion and sends the message to the modules.
If no combustion occurs, the modules shut the gas off at the
gas valve.
When the Power/Pump switch is in the power position, a red
glow should be seen in each porthole in the front of the fryer.
If no red glow is seen, proceed with the following:
1. Remove electrical power supplied to the unit.
Remove electrical power supplied to the unit by unplug-
ging the unit, or by turning off the wall circuit breaker,
or electrical shock could result.
‘2. Remove the side panel.
3. Locate and remove the wire nuts on the leads to the
ignitors.
4. The ignitor should ohm out at 1.0-6.0 ohms.
The following checks are performed with the wall
circuit breaker closed and the Power/Pump switch in
the Power position. Extreme caution should be taken.
Make connections before applying power, take reading,
and remove power before removing meter leads, or
electrical shock could result.
5. Also, a voltage check can be taken. The ignitor should
receive 24 volts from the ignitor module. If 24 volts is
found from the leads from the modules, then the ignitor
is probably faulty.
If an ignitor is found to be faulty it must be replaced as follows:
1. Remove electrical power supplied to the unit.
Remove electrical power supplied to the unit by unplug-
ging the unit, or by turning off the wall circuit breaker,
or electrical shock could result.
2. emove the side panel.