Filter
Top Products
Model HCS-2/HCW-3/HCW-5/HCW-8
2-8. WATER SUPPLY
CONNECTION
(Continued) This unit as manufactured requires the installation of an
appropriate back-siphoning device (as per National Plumbing
Code ASA-A40.8-1955) to be connected to the water inlet
line. This device to be connected in accordance to the basic
plumbing code of the Building Officials and Code
Administrators International, Inc. (BOCA), and the Food
Service Sanitation Manual of the Food and Drug Administration
(FDA).
A water shut-off valve should be installed in a convenient
location.
2-9. LIGHT BULBS AND
GLASS PANELS 1. Cut the tape holding the doors shut and remove all boxes and
boxes and packing. One carton contains the glass panels and
the other contains the light bulbs.
2. Install the light bulbs and glass panels.
3. The unit is now ready to be cleaned per instructions in the
Operations section of this manual.
Replacing Light Bulbs
Light bulbs and glass may be hot. Severe burns could result.
1. Remove the glass panel by carefully pushing up on back of
panel and sliding away from you. The panel will fall into
your hand. See photo at left.
2. Remove the light bulb.
3. Replace the light bulb with a Westinghouse #60A19/35,
130 Volt bulb.
If this bulb is not available, a standard 60 watt bulb will work
until a long life bulb can be obtained.
4. Replace the glass panel.
2-6 103
Step 2
Step 1