Filter
Top Products
Model HCS-2/HCW-3/HCW-5/HCW-8
2-3. LOCATION Place the unit on a table, preferably with a cut-out opening below
the cabinet to allow easy service connections and serviceability.
When setting up the Henny Penny Heated Display Cabinet, be sure
to level the table.
The unit has built-in draining capabilities, but this becomes
ineffective when set on an unlevel table.
After the Henny Penny Heated Display Cabinet has been leveled
on the table, run a bead of silicone rubber (silicone or equivalent
sealant must be a NSF listed material) around the perimeter of the
unit sealing it to the table top. You are now ready to make the
electrical and drain connections to the unit.
2-4. REMOVE CONTROL END 1. Remove the seven screws fastening the end panel to the cabinet.
PANEL
2. Slide bottom of end panel out first allowing top to drop below
shelf edge.
103 2-3
Step 2