Filter
Top Products
–6–
PL-40838-1
LOWER GUIDE HOLDER
LOWER BLADE GUIDE ASSEMBLY
CARRIAGE
In use, the carriage can roll back and forth between the left carriage stop (Fig. 9) and the right carriage
stop, assuming the spring loaded carriage lock (Fig. 5) has not locked the carriage in a stationary
position.
To remove the carriage, turn either of the carriage stops 90 degrees so the bumper is toward the rear
(Fig. 10). Roll the carriage off either end while lifting it free of the carriage support structure (Fig. 9).
To reinstall the carriage, hold the carriage so the bearings (underneath) are aligned with the carriage
support structure. Roll the carriage into place. Return the carriage stops so the carriage is stopped
at both ends.
Fig. 9 Fig. 10
LOWER BLADE GUIDE
The lower blade guide assembly fits in the lower guide holder (Fig. 11). The blade fits in the slots of
both the steel saw blade guide and the plastic guide. When the right table is removed and the plastic
guide is hinged up, the lower blade guide assembly can be removed for cleaning by lifting it out of the
lower guide holder.
The steel saw blade guide is available in various widths depending on the blade being used. Contact
Service to change the steel saw blade guide for other blade widths.
Fig. 11
PL-40836-1
CARRIAGE
RIGHT TABLE
UPPER GUIDE AND GUARD
LEFT TABLE
LEFT CARRIAGE STOP
CARRIAGE SUPPORT
LEFT CARRIAGE STOP
WITH BUMPER TOWARDS
THE REAR
PL-40837-1