Filter
Top Products
– 16 –
Setting the Cooking Core Probe Temperature
1. Insert the pointed end of the core probe into
the product so that the tip is approximately in
the middle of the product to be cooked.
2. Load the product into the oven.
3. Run the probe cable out the side of the door
opening and close the door.
4. Connect the temperature probe (Fig. 6) to the
connector below the control panel.
5. Press and hold the Selection Line Button next
to the Timer icon. The icon will change to the
Core Probe icon and display the set core probe
temperature.
6. Press the Selection Line Button next to the
Core Probe icon. The icon will be highlighted
to indicate that it has been selected.
7. Use the Plus/Minus Buttons to adjust the core
probe set temperature. After a few seconds the
Core Probe icon will change contrast and the
current temperature measured by the probe
will be displayed.
8. Set all other cooking mode settings.
9. Press the START/STOP Button.
Setting Delta T
1. Select the cooking mode by pressing the
Convection Button and/or Steam Button.
2. Press and hold the Selection Line Button
next to the Temperature icon. The icon will
change to the Delta T icon and display the
set temperature difference between the oven
cavity and the core probe.
3. Press the Selection Line Button next to the
Delta T icon. The icon will be highlighted to
indicate that it has been selected.
4. Use the Plus/Minus Buttons to adjust the Delta
T set point temperature. After a few seconds
the Delta T icon will change contrast and
the current oven cavity temperature will be
displayed.
5. Set the core probe temperature by following
the instruction above.
6. Set all other cooking mode settings.
7. Press the START/STOP Button.
CORE PROBE
Fig. 6
350
°F
PH
1/1
3
START
CORE PROBE
ICON
170
°F
PH
1/1
START
3
DELTA T
ICON
USING THE PRODUCT TEMPERATURE PROBE