Hobart ML-132178 Oven User Manual


 
– 18 –
Control Guide - Advanced (cont)
Button Action Display
Press to stop the BAKE The ON light is off when the BAKE TIMER is inactive.
TIMER or silence the
beeper after the BAKE
TIMER has timed out.
PROGRAM
Press the The PROGRAM window displays the number of the
arrow keys to select current program.
a bake program.
STEP
Use to enter bake programs. The corresponding indicator light will be lit (1 to 4),
depending on which step is selected.
Press to open or The indicator light next to the VENT button is lit when
close the vent. the vent cycle is enabled.
Auto ON/OFF Timer
Timer Settings
Auto ON/OFF Timer display shows the current time of day. To adjust the current time of day, press and
hold either of the arrow buttons until the colon between the hours and minutes display stops blinking.
Use the up and down arrow buttons to adjust time of day. After 5 seconds of no use, the colon will start
to blink again.
The oven can be set to turn itself on and off. After the Auto ON/OFF Timer is set, the POWER ON OFF
button can be pressed to turn the oven off. This will not disrupt the AUTO ON/OFF setting. Electrical
power to the oven must remain on.
1. To set the oven to turn on, press and
hold
the AUTO ON TIME button. The previously entered start
time will appear in the display. Use the UP and DOWN arrows to adjust the start time. Then
release the AUTO ON TIME button.
2. To set the oven to turn off, press and
hold
the AUTO OFF TIME button. The previously entered
end time will appear in the display. Use the UP and DOWN arrows to adjust the end time. Then
release the AUTO ON TIME button.
3. To enable the automatic start, press the TIMER ON/OFF button until the indicator LED to the right
of the TIMER ON/OFF button is illuminated.
Backup Battery
The clock is backed up by a lithium battery which keeps the clock circuitry operating when all external
power is off. If the battery becomes low or dead while the external power is off, the display will read
12:00 (12 hr mode) or 0:00 (24 hr mode) and will not increment until a new time is set. The clock will