Filter
Top Products
– 11 –
Changing Quick Set Programs
1. When the power is turned on, the oven defaults to QUICK SET-1.
2. Press TEMP. and enter 99 on the number keypad. Repeat this step for TIMER, STEAM and
DELAY.
3. Wait for displays to change to 0.
4. Press TEMP. and enter the new temperature value on the number keypad. Repeat this step for
TIMER, STEAM and DELAY. These settings are optional and can be left at 0 if desired. To clear
an entry, press desired entry again.
5. Press QUICK SET and enter the selected number for the QUICK SET program you want to
change. Press START. The displays will read 0 when the new settings have been accepted.
6. Turn power switch to OFF for at least 3 seconds and then turn it back ON.
Using Quick Set Programs
1. Press QUICK SET and enter the QUICK SET number (1 through 84) on the keypad for the
program you want to use. The TEMP., TIMER, STEAM and DELAY settings are displayed.
2. Confirm that the oven is at the set baking temperature.
3. Slowly open the door. Wait for the rack lifting device to lower and come to a stop.
4. Roll the loaded rack onto the rack carrier until it touches the rear carrier stop and then latch front
carrier stop. (See Loading and Unloading Procedures.)
5. Close and latch the door.
6. Press START.
7. A buzzer will sound after the TIMER expires. Press STOP to silence the buzzer.
Quick Set Hints
• The oven defaults to the QUICK SET-1 settings when turned on. It may be helpful to set QUICK
SET-1 for the desired preheat settings during oven startup.
• Any combination of bake settings can be manually entered on the control pad for one-time
custom-baking operations. These settings are not saved to the Quick Set program memory.