Filter
Top Products
– 15 –
OWNER PREVENTIVE MAINTENANCE PROCEDURE
INTRODUCTION
This owner preventive maintenance (PM) section includes procedures to inspect for proper operation
and cleaning of components. Owner PM procedures are written for gas ovens. They can also be used
for electric ovens by omitting the steps that refer to components found only on gas ovens. Owner PM
should be conducted bi-monthly per OSHA Bakery Oven Inspection Standard 29 CFR 1910.263(l)(9)(ii).
A convenient PM checklist is provided at the end of this section.
NOTE: This PM procedure does not discuss repair or replacement of components. Upon completion
of the PM procedure you will need to contact a qualified servicer for any needed repairs.
Tools Used For Inspection Procedure
• Standard set of hand tools
• Vacuum cleaner - shop vac
PREVENTIVE MAINTENANCE PROCEDURE
WARNING: DISCONNECT THE ELECTRICAL POWER TO THE MACHINE AND FOLLOW
LOCKOUT / TAGOUT PROCEDURES.
WARNING: SHUT OFF THE GAS BEFORE SERVICING THE UNIT.
WARNING: CERTAIN PROCEDURES IN THIS SECTION REQUIRE ELECTRICAL TEST OR
MEASUREMENTS WHILE POWER IS APPLIED TO THE MACHINE. EXERCISE EXTREME
CAUTION AT ALL TIMES. IF TEST POINTS ARE NOT EASILY ACCESSIBLE, DISCONNECT
POWER AND FOLLOW LOCKOUT / TAGOUT PROCEDURES, ATTACH TEST EQUIPMENT AND
REAPPLY POWER TO TEST.
Inspect Oven Lamps
1. Lamps should be on when oven is powered.
2. If not, replace lamps.
A. Remove screws securing lamp compartment cover (Fig. 1) and pull cover towards you to
disengage cover from rear tabs.
3. Twist lamp (Fig. 2) to disengage from lamp sockets (Fig. 2) and carefully withdraw lamp from
area.
4. Reverse procedure to install new lamps.
Fig. 1
Fig. 2