Filter
Top Products
– 3 –
© HOBART CORPORATION, 1992
Installation, Operation, and Care of
QE, EQE, QEH, & PEQ SERIES
ROLL-IN FOOD STORAGE CABINETS & PROOFERS
SAVE THESE INSTRUCTIONS
GENERAL
The QE and EQE Series Roll-in Food Storage Cabinets are available as medium temperature (38°F)
or frozen food (0°F) storage cabinets. The QEH Series is available as a hot food (180°F) storage
cabinet. QE, EQE, and QEH Series may be ordered as one-, two-, or three-section, roll-in or roll-
through cabinets. The PEQ Series may be ordered as one-, two-, or three -section roll-in or roll-through
proofer cabinets for the baking industry. Proofer cabinets control temperature, humidity, and time.
Thaw Proofer cabinets have a two-stage control, an initial Thaw stage is automatically followed by a
Proof stage; each stage independently controls temperature, humidity, and time.
INSTALLATION
UNPACKING
Immediately after unpacking, check for possible shipping damage. If the cabinet is found to be
damaged, save the packaging material and contact the carrier within 15 days of delivery.
Prior to installation, test the electrical service to verify that it agrees with the data plate located in the
upper left corner inside the cabinet.
ASSEMBLY
Some components can be removed to allow the cabinet
to pass through short or narrow doorways.
The door handle can be removed, as follows:
1. Remove the screw and bolt from the tumbler.
2. Remove the two mounting screws and the handle
assembly (Fig. 1).
3. Replace in reverse order of disassembly.
NOTE: Proofers do not have locks.
PL-50949
DOOR
BOLT
SCREW
ASSEMBLY
MOUNTING
SCREW
HANDLE ASSEMBLY
KEY
MOUNTING SCREW
PLUG
BUTTON
Fig. 1