Filter
Top Products
– 5 –
On pass thru models, the recessed floor dimension allows 2
1
/4" clearance at both front and rear and
1
/2" on both sides. On a front opening cabinet, the recessed floor dimension allows 2
1
/4" clearance at
the front, 1
1
/2" clearance at the rear, and
1
/2" on both sides (Fig. 5). The plug for the heater under the
flat threshold must be connected to the receptacle, provided, before installing grout.
The space between the cabinet base and the recessed opening must be filled with grout for sanitary
purposes. DO NOT fill the area below or above the hinge plate with grout, as the fastener on the bottom
of the hinge plate must remain accessible to remove the door for service. Place a piece of cardboard
around the hinge plate to make sure this area is free of any grout. Keep grout away from heater plug.
Ramp (Equipped as an Alternate to Flat Threshold)
Install ramp(s) and ramp heater(s) as follows:
The heater is secured to the bottom of the ramp
(Fig. 6). Connect the heater plug into the receptacle
provided at the bottom of the door opening (Fig. 6).
Position the ramp by placing the lip of the ramp
inside the door opening. Hook the ramp on the clips
provided at the bottom of the door opening (Fig. 6).
Ramp heaters are not used on QEH or PEQ models.
Shelves (Fig. 7)
The shelves and shelf clips are provided only if specially
ordered. Insert shelf clips in pilaster slots and install the shelves.
Index holes are provided in the pilaster to help in leveling the
shelves.
Bonus shelves are provided to fill the space between the
standard shelves. These are positioned and supported by the
standard shelves.
NOTE: Loosen all thumb screws which secure shelf pilasters
and light cover(s) prior to placing product in cabinet. Thumb
screws should be loose enough to remove with your fingers so
parts can be readily removed for cleaning without the use of
tools. Failure to comply with this request will invalidate the NSF
listing.
Miscellaneous
Some models have the compressor specially mounted to help prevent damage during shipment. If the
compressor is mounted on shipping blocks, they must be removed prior to operation. If the compressor
is mounted on springs, refer to the tag attached to the compressor.
On cabinets with remote refrigeration systems, place the condensate dish heater in the condensate
dish and connect it to the outlet provided.
PL-50910
BONUS
SHELF
SHELF
SHELF
CLIP
PILASTER
INDEX
HOLE
COLD AIR
DUCT
Fig. 6
Fig. 7