Filter
Top Products
10
Pull Unicouple and its hoses completely out from storage compartment located at rear of dishwasher
and attach it to the faucet adapter.
Turn water fully on before starting the dishwasher.
3
1
Turn off the water.
Release the water pressure by depressing the pressure release button. This relieveswater pressureand protects you, andthe
room, from severe splashing.
Release Unicouple from faucet by depressing the collar at the top of the Unicouple connector.
3
2
1
Remove the power cord plug from the wall receptacle.
Disconnect Unicouple from faucet adapter.
2
1
If faucet has not threads: attach thefaucet adapter to faucet, then tightenevery screw
of the adapter. To preventleaking your should tightenthe adapter.
2
Attach the Unicouple connector to the faucet adapter by depressing the collaratthetopoftheconnector.
When Unicouple is all the way up onto the adapter, release the collar. It willthensnapIntopositionto
lock the Unicouple in place. The Unicouple s small hose carries water from the faucet to the dishwasher.
Its large hose carries drain water to the sink. Be sure Unicouple is pointing toward the sink bowl drain
opening and the sink drain is open for water that will drain from your dishwasher. If your dishwasher
drains into a disposer, operate the disposer until it is completely empty before starting the dishwasher.
'
A hosethat attachesto asink spray canburstif it is installed onthe same water line asthe dishwasher.If yoursink has one,itis
recommended thet thehose bedisconnected and the hole plugged.
Fusedelectrical supply is required-copper wire only.Time delay fuse orcircuit breaker recommended and provide separate
circuit serving only this appliance. Outlet should be placed in adjacent cabinet.
Make sure that the plug on the appliance remains accessible after installation.
After making sure that the voltage and the frequency values for the current in the home
correspondto those on the rating plate andthatthe electricalsystem is sized for the
maximumvoltage on therating plate, inserttheplug intoan electrical socket which is
earthedproperly. If the electricalsocketto which the appliancemust be connected is not
appropriate forthe ,replace the socket ,rather than
using aadaptors or the like as they couldcauseoverheating and burns.
plug (installed bya qualified electrician)
Theappliance mustbe connected to the water mains usingnew hose-sets.
The old hose-sets should notbe reused.
Water pressure must be between 0,04 MPa and 1 MPa. If the pressure is below theminimum
consultour Service Department foradvice.