Filter
Top Products
11
If the sink is 34 or higher from the floor, the excesswater in Unicouple hoses
cannot be drained directly into the sink. It will be necessary to drain excess
water from hoses into a bowl or suitable container that is heldoutside and lower
than the sink.
Connect the cold water supplyhose toa threaded3/4(inch)connector andmake sure thatit is
fastened tightly in place.
If the water pipes are new or havenot been used for an extended period of time, letthe water
runtomakesurethatthewaterisclearandfreeofimpurities.Ifthisprecaution is not taken,
thereis a risk that the water inlet can get blockedand damage theappliance.
The water supply to the appliance can alsobe connected to thehouse hot waterline
(centralized system, heatingsystem),as long as it does notexceed a temperature of 60 C.
In this case, the wash cycle time will be shortened by about 15 minutes and thewash
efficiencyslightly reduced.
Theconnection must be made tothe hot water line following the sameprocedures asthose
for the connection to thecold water line.
DIMENSIONS(mm)
Insert the drain hoseinto a drain pipe witha minimum diameter of4 cm, orlet itrunintothesink,makingsuretoavoidbending
or crimping it. Use the special plasticsupport that comeswith the appliance. The free endof thehose must be at a height
between 40 and 100cm andmust not beimmersed in water.
Oncethe applianceis positioned,adjust the feet (screwingthemin or out) to adjust the
heightofthe dishwasher, making it level.In any case ,the appliance should notbeinclined
more than 2 .
Position the appliance in the desired location. Theback should rest against the wallbehind it, andthe sides, along the adjacent
cabinets or wall. Thedishwasher isequipped withwater supplyanddrainhoses that canbe positionedto the right or the leftto
facilitate properinstallation.
450
580
850
1135
φ 40mm