Filter
Top Products
30
5. Sanitizing Procedure - Final
1) Remove the drain plug to drain any remaining solution.
2) After all of the solution has drained, replace the drain plug in its correct position.
3) Remove the reservoir cover. Pour the sanitizing solution into the reservoir until the
solution starts to ow through the overow hose.
4) Allow the icemaker to sit for 10 minutes before operation.
5)Plugtheunitbackin.Movethepowerswitchtothe"ON"position.
6) Allow the unit to make ice using the solution. When ice stops coming out, move the
powerswitchtothe"OFF"position.Unplugtheunitfromtheelectricaloutlet.
7) Remove the drain plug to drain any remaining solution.
8) After all of the solution has drained, replace the drain plug in its correct position.
9) Remove the reservoir cover. Using a clean container, pour water into the reservoir until
it starts to ow through the overow hose. Replace the reservoir cover in its correct
position.
10) Remove the drain plug to drain the water.
11) After all of the water has drained, replace the drain hose, drain plug, drain clamp and
all other removed parts in their original and correct positions. WARNING! CHOKING
HAZARD: Ensure all components, fasteners, and thumbscrews are securely in place.
Make sure that none have fallen into the storage bin.
12) Open the water supply line shut-off valve. Check for leaks.
13)Plugtheunitbackin.Movethepowerswitchtothe"ON"positionandallowthe
icemaker to run.
14)After30minutes,movethepowerswitchtothe"OFF"position.Unplugtheunit.
15) Pour warm water into the storage bin to melt all of the ice, then clean the storage bin
liner, door liner, and door gasket with a neutral cleaner. Rinse thoroughly after cleaning.
16)Plugtheunitbackin.Movethepowerswitchtothe"ON"positiontostarttheautomatic
icemaking process.