Hoshizaki C-100BAF Ice Maker User Manual


  Open as PDF
of 34
 
31
B. Maintenance
The maintenance schedule below is a guideline. More frequent maintenance may be
required depending on water quality, the icemaker's environment, and local sanitation
regulations.
WARNING
1. Only qualied service technicians should attempt to service this icemaker.
2.Movethepowerswitchtothe"OFF"positionandunplugtheunitfromthe
electrical outlet before servicing.
Maintenance Schedule
Frequency Area Task
Weekly Scoop Clean the scoop using a neutral cleaner. Rinse thoroughly after cleaning.
Monthly External Water
Filters
Check for proper pressure and change if necessary.
Icemaker Exterior Wipe down with clean, soft cloth. Use a damp cloth containing a neutral
cleaner to wipe off oil or dirt build up. Clean any chlorine staining (rust
colored spots) using a non-abrasive cleaner like Zud or Bon Ami.
Every 3
Months
Storage Bin Drain Maintainasoutlinedin"III.B.1.StorageBinDrain."
Every 6
Months
Icemaker and
Storage Bin
Clean and sanitize per the cleaning and sanitizing instructions provided in
thismanual.See"III.A.CleaningandSanitizingInstructions."
Evaporator
Condensate Drain
Pan and Gear
Motor Drain Pan
Wipe down with clean cloth andwarm water.
Yearly Water Supply Inlet Close the icemaker water supply line shut-off valve and drain the water
system. Clean the water supply inlet screen.
Condenser Inspect. Clean if necessary. See"III.B.2.Condenser."
Water Hoses Inspect the water hoses and clean/replace if necessary.
Upper Bearing
(extruding head)
Checkforwearusing.02"roundstockorpingauge.Replacebothupper
bearing and lower bearing if wear exceeds factory recommendations. See
the Service Manual for details.
After
3 Years,
then Yearly
Upper Bearing
(extruding head);
Lower Bearing
and O-Ring
(lower housing);
Mechanical
Seal; Evaporator
Cylinder; Auger
Inspect. Replace both upper bearing and lower bearing if wear exceeds
factory recommendations. Replace the mechanical seal if the seal's contact
surfaces are worn, cracked, or scratched.
Gear Motor
Drain Pan
Evaporator
Condensate
Drain Pan
 previous next