Hoshizaki C-100BAF-DS Ice Maker User Manual


  Open as PDF
of 34
 
29
12) Allow the icemaker to sit for 10 minutes before operation. If you placed a clamp on the
reservoir hose in step 11, remove it before operation and replace the spout in its correct
position.
13)Plugtheunitbackin.Movethepowerswitchtothe"ON"position.
14) Allow the unit to make ice using the solution. When ice stops coming out, move the
powerswitchtothe"OFF"position.Unplugtheunitfromtheelectricaloutlet.
15) Remove the drain plug to drain any remaining solution.
16) After all of the solution has drained, replace the drain plug in its correct position.
17) Remove the reservoir cover. Using a clean container, pour water into the reservoir until
it starts to ow through the overow hose. Replace the reservoir cover in its correct
position.
18) Remove the drain plug to drain the water.
Note:Ifyoudonotsanitizetheicemaker,gotostep11in"SanitizingProcedure-Final."
19) After all of the water has drained, replace the drain plug in its correct position.
3. Sanitizing Solution
IMPORTANT
For safety and maximum effectiveness, use the solution immediately after
dilution.
Dilute 1.25 . oz. (37 ml or 2.5 tbs) of a 5.25% sodium hypochlorite solution (chlorine
bleach) with 2.5 gallons (9.5 l) of warm water. This is a minimum amount. Make more
solution if necessary.
Using a chlorine test strip or other method, conrm that you have a concentration of
about 200 ppm.
4. Sanitizing Procedure - Initial
1) Remove the reservoir cover. Pour the sanitizing solution into the reservoir until the
solution starts to ow through the overow hose. Replace the reservoir cover in its
correct position.
2) Remove the spout and packing.
3) Pour some of the sanitizing solution into a separate, clean container. Use this sanitizing
solution and a clean cloth to wipe down the slope, scoop, scoop holder, spout, and
packing.
4) Rinse the parts thoroughly with clean water.
5) Replace the packing and spout in their correct positions.
6) Make sure at least 10 minutes have elapsed since you poured the sanitizing solution
intothereservoir,thenplugtheunitbackin.Movethepowerswitchtothe"ON"
position.
7) Allow the unit to make ice using the solution. When ice stops coming out, move the
powerswitchtothe"OFF"position.Unplugtheunitfromtheelectricaloutlet.
 previous next