Filter
Top Products
44
10. Pour the cleaning solution carefully into the Reservoir through the opening in the center
of the
Storage bin up to an overflow level. (Solution that has overflowed can be seen
in the Drain Pan.)
11. While waiting for 10 minutes to start icemaking process, wipe the Bin Liner and the
Drip Plate using a clean cloth containing the cleaning solution.
12. Replace the Drip Ring and Agitator.
13. Move the Ice Making Switch and then the Power Switch to the “ON” position. Place
the Storage Bin Cover in position, and start the automatic icemaking process. Run the
ice dispenser until it stops automatically.
14. Move the Ice Making Switch to the “FLUSH” position, and wait for flush process to
begin (60 seconds).
15. Pour clean, warm water carefully onto the Bin Liner, Agitator, Drip Ring and into the
Reservoir through the opening in the center of the Storage Bin to melt the ice and
rinse out the cleaning solution.
16. Move the Power Switch to the “OFF” position.
17.
Wipe the Storage Bin Cover and Spouts (A) and (B) using a clean cloth containing the
cleaning solution.
18. Rinse the wiped parts with water. Be careful not to wet the Bin Control Switch on the
Storage Bin Cover.
CAUTION
Do not use ice produced with cleaning and sanitizing solutions. Be sure none
remains in the Storage Bin.