Filter
Top Products
16
16) Wash the Bin Control Switch, Water Tank, Float Switch, Cube Guide, Silicone Hose
and Overflow Pipe by using a nylon scouring pad, brushes and the cleaning solution.
In addition to the removed parts, also wash the bin liner and Bracket (L) (R) with the
solution.
17) Discard the cleaning solution and rinse the parts thoroughly with water.
2. Sanitizing Procedure - Following Cleaning Procedure
1) Dilute approximately 0.5 fl. oz. (15 ml or 1 tbs) of a 5.25% sodium hypochlorite solution
(chlorine bleach) with 1 gallon (3.8 lit.) of warm water. Using a chlorine test strip or
other method, confirm that you have a concentration of about 200 ppm.
2) Soak the removed parts from step 16 above in a clean container containing the
sanitizing solution. After allowing the parts to soak for 10 minutes, wash them with the
solution. Also wash the bin liner, Bracket (L) (R) with the solution.
Fig. 8
Cube Guide
* This illustration shows KM-61BAH.
The following number of Cube
Guides are provided:
KM-61BAH 2 pcs
KM-101BAH 3 pcs
KM-151BAH 3 pcs
KM-151BWH 3 pcs
Snap
Water Tank
Bin Control Switch
* The Bin Control Switch is accessible by
removing the Water Tank. Pull the switch
towards you for easy maintenance.
* This is the front view with the Door opened
and the Water Tank removed.