Filter
Top Products
69
Fig. 19
Spray Tube
Front Separator Pin
3) Remove the top cover and front cover. See Fig. 19.
4) Disconnect the silicone hose from the spray tube, and remove the spray tube from
the evaporator bracket.
5) Remove the front separator by pushing the pins inserted into both sides of the
evaporator bracket toward the center. See Fig. 19.
Note: Be careful not to break the pins.
6) The rear separator is hooked on the groove in the evaporator bracket. Remove the
rear separator by lifting it up and down. See Fig. 19.
7) Refi t the separators in the reverse order of the removal procedure. Check that the
separators are fi t correctly and can swing like a pendulum.
8) Plug in the icemaker or connect the power source.
Silicone Hose
Front Cover
Top Cover
Rear Separator