Filter
Top Products
Introduction to Hotpoint – EH10
Your new cooker is guaranteed and will give lasting
service.
To help make the best use of your Hotpoint cooking
equipment please read this booklet carefully.
The cooker is designed specifically for domestic use
and responsibility will not be accepted for use in any
other installation.
When first using the cooker ensure that the room is
well ventilated (e.g. open a window or use an extractor
fan) and that persons who may be sensitive to the
odour avoid any fumes. It is suggested that any pets be
removed from the room until the smell has ceased.
This odour is due to temporary finish on oven liners
and elements and also any moisture absorbed by the
insulation.
This guarantee is only applicable if the appliance
has been installed in accordance with the
installation instructions detailed in this
booklet.
Note:
3
Installation
THIS APPLIANCE MUST BE EARTHED.
Your cooker should have been checked to ensure
that
the voltage corresponds with your supply volt
age,
this is
stated on the rating plate, which is situated
on the front
of the plinth. The cooker must be connected by a
competent person e.g. (NICEIC registered contractor)
to suitable double-pole control unit with a minimum
rating of 30A and a minimum contact clearance of
3mm, which should be fitted adjacent to the cooker, in
accordance with IEE regulations. The control unit but
must be within 2 metres of but not directly above the
appliance and should be easily accessible in the event
of an emergency.
The power supply cable should conform to B.S.6004
with a conductor size of 6mm
2
minimum.
Access to the mains terminals is gained by removing
the rear access cover. The mains cable must pass
through the cable clamp adjacent to the
terminal block. Sufficient cable should be used to allow
the cooker to be pulled out for servicing.
Ensure that the mains cable is routed away from
any brackets affixed to the rear panel and is not
trapped to the rear wall when pushing the cooker
into position between cabinets.
This appliance conforms to EN 55014 regarding
suppression of radio and television interference.
Warning
Mains Connection
Radio Interference