Filter
Top Products
4GB
INSTALLATION
Assembly Instructions
The accessories required for the installation of the
hood can be found inside the packaging. The hood
is convertible and can therefore be installed for use
in either the OUTDOOR VENTING mode or the
AIR RECIRCULATION mode. If the hood is used
in the OUTDOOR VENTING mode, connect
opening ‘N’ (Fig.1) to an exhaust duct connected
directly to the outside and which is 150cm
2
minimum in cross-section. The lowest part of the
hood should be at least 70cm from the hob.
• IN NO CASE WHATSOEVER SHOULD THE
HOOD BE CONNECTED TO EXHAUST
DUCTS FROM OTHER APPLIANCES
THAT RUN ON ENERGY SOURCES OTHER
THAN ELECTRICITY (water heaters, boilers,
stoves etc.). The hood must not be placed above
stoves with a top radiant hob.
• There are 3 main types of supports for
anchoring a hood onto a wall. As a rule each
hood has tow main anchoring points, one at either
side on the back of the hood.
1ST TYPE OF SUPPORT
• This support is assembled onto the hood and allows for the adjustment of the hood both vertically
(screw L, Fig.2) and horizontally (screw F, Fig.2). For the installation, L-shaped hooks must be
fastened to the wall (see E, Fig.2).
2ND TYPE OF SUPPORT
This support is already assembled on the cooker
hood and only allows vertical adjustment, by
turning the screw situated on the high part of the
hood (see Side b). L-shaped hooks must be fastened
to the wall for installation.